LIVE-EDGE MAINTENANCE & CARE GUIDE

1. Dusting

• Frequency: Daily or as needed
• Use a soft, dry microfiber cloth to dust your table. Regular dusting prevents scratches and helps keep the wood looking vibrant.

2. Wiping

• Frequency: Once a week or as needed
• Lightly dampen a cloth with water to wipe the surface. Avoid excess water, as it can damage the finish and the wood over time.
• For Osmo & Oil Finishes: Avoid chemical cleaners that may strip the finish. Use a mild soap solution (1 drop of mild dish soap in a quart of water) for tougher spots, followed by a clean, damp cloth to remove residue.
• For Polyurethane Finishes: Polyurethane provides a sealed surface, so you can use a slightly stronger mix (up to 2 drops of mild soap per quart of water), but avoid harsh chemicals that could dull the finish.

Refreshing the Finish

• Frequency: Every 3-6 months or as needed (Dry or chemical exposure)
• For Osmo Finish: Apply a pea-sized amount of Osmo Liquid Wax Cleaner on a clean, lint-free cloth. Buff lightly, focusing on high-use areas. Let dry for 30 minutes before use.
• For Oil Finish: Lightly oil the surface with a food-safe mineral oil, tung oil or Odie’s Oil, using about 5-10ml per square meter. Apply in the direction of the grain, let sit for 5 minutes, then wipe off excess with a soft cloth. Allow to dry for 8-10 hours.
• For Polyurethane Finish: A quick wipe-down with a slightly damp cloth should be sufficient. Avoid additional products, as polyurethane seals the wood and does not require conditioning.

1. Reapplying Finish

• Frequency: As needed for high-traffic tables
• For Osmo and Oil Finishes: Lightly sand with 400-grit sandpaper if necessary. Reapply Osmo TopOil or tung oil to rejuvenate the table’s appearance and add durability. Follow the product’s instructions for the amount and drying time.
• For Polyurethane Finish: If the polyurethane finish has worn, lightly sand the affected area and apply a new coat of polyurethane, following the manufacturer’s instructions.

2. Water Rings & Minor Marks

• Frequency: Monthly inspection
• Tip for Water Rings (All Finishes): Mix equal parts olive oil and white vinegar (1 teaspoon of each is usually enough). Dip a soft cloth in the mixture and rub it gently on the water ring in circular motions. Wipe with a clean, dry cloth afterward.
• For Osmo and Oil Finishes: For minor scratches, buff with a soft cloth and a small amount of Osmo Liquid Wax Cleaner or an appropriate wood cleaner to help blend marks into the finish.
• For Polyurethane Finishes: Lightly buff scratches with a cloth and a polyurethane-safe polish.

• Coasters & Placemats: Use coasters under drinks and placemats under hot or cold items to avoid water rings and heat marks. Ensure the surface is dried before replacing objects.
• Placement: Keep your table out of direct sunlight to prevent fading, and avoid placing it near heat sources.
• Humidity Control: Keep indoor humidity between 35-55%. Low humidity can cause cracking, while high humidity can lead to swelling. A dehumidifier or humidifier can help maintain this balance.